A wall light in a child's room: where and how to install it safely

Applique murale en bois avec halo lumineux au-dessus d’une commode d’enfant

A wall light frees up the bedside table and, when it illuminates the wall from behind, gives a gentle glow without glare. Correct installation matters. Check these points before drilling.

1. Choose the position

  • Out of reach: install it high enough that your child cannot grab it from the bed or by climbing furniture.
  • Away from the eyes: avoid placing it immediately above the pillow. A side wall or above a dresser lets the glow reach the room without shining towards the eyes.
  • Near a socket: plan the cable route to avoid extension leads.

2. Match the fixings to the wall

The right hardware depends on the surface: plasterboard anchors, suitable masonry plugs for brick or concrete, or wood screws for a wooden wall. If in doubt, ask a hardware specialist and bring the lamp's weight information. Do not rely on adhesive or a nail for an object hanging above a bed.

3. Secure the cable

Cable management is crucial in a child's room. Run it down the wall, secure it with clips or trunking, and leave no accessible loops. Never route it near the bed.

4. Suitable power

Our wall lights: USB 5V. Use a compliant USB adapter for your country and unplug the light before cleaning.

5. Store the remote safely

Keep any remote out of reach: small batteries are dangerous if swallowed. For ORAWOOD Original and Mini tabletop lights, the remote control battery is not supplied for safety reasons. The in-line cable switch also turns the light on and off.

Prefer not to drill?

A freestanding light on a dresser or shelf creates the same atmosphere without wall installation. Compare formats in our night-light guide.